|
The Soviet Yakovlev Yak-7 was developed from the earlier Yak-1 fighter, initially as a trainer but converted into a fighter. As both a fighter and later reverting to its original training role, the Yak-7 proved to be a capable aircraft and was well liked by air crews. The Yak-7 was simpler, tougher and generally better than the Yak-1.〔Taylor 1985, p. 122.〕 ==Design and development== In 1939, Alexander Yakovlev designed a tandem-seat advanced trainer, originally designated "I-27" and then "UTI-26", offered along with the original I-26 proposal that became the Yak-1. The "UTI" (''Uchebno Trenirovochnyi Istrebitel'', translated as: Training Fighter) was intended to give pilots-in-training experience on a high-performance aircraft before transitioning to a fighter. With development work started in 1940, the UTI-26 differed from its predecessor in its larger span wing being placed farther back for balance as well as having two cockpits with dual controls and a rudimentary communication system. It was armed with a single ShKAS machine gun in the cowling, mainly for use in training, but Yakovlev envisioned a multi-purpose aircraft that could also undertake courier and light transport duties at the front. The first production aircraft known as Yak-7UTIs retained a retractable main landing gear, but beginning in the summer of 1941, a fixed landing gear variant, the Yak-7V (Vyvozoni for Familiarization) was substituted. The factory reasoned that production would be simplified and that reduced performance would not be detrimental for a trainer. Yak-7UTIs and Yak-7Vs were also equipped with skis for winter operations. A factory team from N° 301, headed by K.A. Sinelshchikov, was detached from the Yakovlev OKB to supervise production of Yak-7UTI. One of these aircraft (serial number 04-11) was fitted with an armored backrest plate over the rear position, self-sealing fuel tanks which filled with inert gas as they emptied, three "RO" rocket launchers under each wing for as many RS-82 rockets, an axial ShVAK cannon firing through the propeller spinner, with 120 rounds, and two 7.62 mm ShKAS machine guns under the cowling, each with 750 rounds.〔Leonard 2005, p. 60.〕 The rear cockpit position was retained, allowing it to accommodate a second seat (without controls) for fast courier and transport duties or a fuel tank for extended range. The additional space could also house bombs or other gear. The engine was an M-105P and the model was designated Yak-7/M-105P. Sinelshchikov did not inform Yakovlev about the conversion and when he learned about it, Yakovlev remained sceptical of the need for the changes.〔 After brief factory trials, the aircraft turned out to be better than the single-seat Yak-1, thanks to the modifications already applied to the UTI as well as revised undercarriage with bigger tires and wheels, more efficient brakes and revised elevators, among other changes. Yakovlev submitted the Yak-7 to the authorities who approved it immediately. The firing tests at the scientific trials Polygon for aircraft armament (NIPAV) were a success and the armament was found to have no effect on the flight characteristics or the general performances of the new fighter. The aircraft's stability as a firing platform was judged far better than that of the Yak-1, the Lavochkin-Gorbunov-Gudkov LaGG-3 and Mikoyan-Gurevich MiG-3. The GKO and the NKAP issued decrees in August 1941 for the Yak-7 to be produced by Factories N°301 and N°153, but the Factory 301 had to be evacuated to Novosibirsk where it merged with N° 153. So, just 62 aircraft were produced in 1941: 51 in September–October by Factory N° 301 and 11 by N°153 in December.〔 Test pilot A.N. Lazarev noted the good flight characteristics, how easy it was to get out of a spin, how well it behaved when diving, characteristics that he considered safer than those of the Yak-1. But the Yak-7 showed some defects: the M-105P engine piping, the landing gear locking system, the tires and the tail wheel were identified.〔Leonard 2005, pp. 60–61.〕 The Yak-7 was introduced into the production line and the first batch of 60 reached operational squadrons by the end of 1941. Another important variant was the Yak-7/M-105PA. On this model, the two ShKAS on the cowling had been replaced by two UBS machine guns with 400 rounds (260 for the left and 160 for the right). It was powered by an M-105PA engine with an axial ShVAK cannon with 120 rounds. Oil and glycol radiators had been widened and refined and slightly tilted downward. The insulation of the airframe was improved, tail wheel was totally retractable; joints and skin were more carefully made; panels on engine cowling fitted better; the propeller reduction gear worked better; an electro-pneumatic reloading system was installed; canopy frame was reinforced. The Yak-7B made 27 tests flights in January and February 1942. The reports noted that while the aircraft "was not inferior to the LaGG-3 and MiG-3 and to foreign fighters in service in the USSR", it was more stable and had better flight characteristics. Subsequently, the GKO authorised production at Factory N°153 in place of the Yak-7A, from April 1942 and 261 machines were built until July. After 20 May, the aircraft were equipped with a tank behind the pilot’s seat, but the pilots that used the Yak-7 on Stalingrad and on the Kuban removed it as it was not protected and affected the flight characteristics. Generally, the Yak-7B pleased its pilots. They reported that it was easy to fly at all altitudes, stable and easy to maintain and although it did not climb as quickly as a Messerschmitt Bf 109, it was as manoeuvrable and fast, except in the vertical plane. But defects were also noted: there was too much drag from the radiators, the canopy glass was of bad quality; the pilot was not protected enough, taking-off and landing distances were too long and, above all, it was underpowered.〔Leonard 2005, p. 78.〕 Yakovlev suggested Klimov, the engine builder, some modifications that resulted in the M-105PF which was more powerful. With this modified engine, the Yak-7B top speed was of , it climbed much faster up to and it was more manoeuvrable both in the horizontal and the vertical planes. But because the rear tank was removed, its range was reduced and the CG was moved too forward, while M-105 defects (glycol and oil overheating, oil leaks etc.) persisted.〔Leonard 2005, p. 79.〕 Among the engine and armament options was the Yak-7-37 fitted with a MPSh-37 cannon, (MPSh - ''motornaya pushka Shpital'novo'' - engine mounted Shpital'nyy cannon), mounted between the engine cylinder blocks, firing through the propeller spinner. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Yakovlev Yak-7」の詳細全文を読む スポンサード リンク
|